RV Off-Grid Planner

Enter what your RV actually carries and uses. The planner estimates how many days each resource lasts, names the first one to run out, and shows whether your supplies cover the nights you plan to stay. Leave a section blank and it stays out of the estimate. Nothing you enter is saved or sent anywhere.

How to measure your own numbers

The planner is only as good as the daily figures you give it. Published averages and tank sizes are a starting point. Your own measurements are better.

Fresh water use

Fill the fresh tank, note the gauge or the gallons you added, and camp one normal day. Refill to the same mark and count the gallons. Include drinking, cooking, dishes, showers, flushing, and pets. Our water management guide walks through the method and worked examples.

Gray and black tank accumulation

Start with empty tanks and watch the gauge or tank sensor over two or three days. Divide what was added by the days. Tank gauges are often imprecise, so set your planning ceiling below full. Not all fresh water ends up in the gray tank, so measure the two separately. The RV toilet guide covers black tank and cassette care.

Battery use

A battery monitor with a shunt shows amp-hours or watt-hours used per day. Without one, list each appliance’s watts and hours, and use a plug-in power meter for AC devices. For a compressor fridge, enter its average draw over 24 hours, not its running watts.

Generator fuel and propane

Fuel use depends on load. Use your generator maker’s figure at the load you expect, or fill the tank, run a typical session, and measure what it took. Weigh portable propane tanks before and after a typical day to get daily propane use. One propane supply is counted once, even when the generator and the furnace share it.

How the planner calculates

  • Fresh water days = (water on board, including carried jugs, minus your reserve) ÷ daily use.
  • Gray, black, or cassette days = (planning ceiling minus current contents) ÷ daily accumulation.
  • Battery energy available = bank watt-hours × (starting charge minus minimum retained charge).
  • Daily battery use = DC loads + AC loads ÷ inverter efficiency + inverter idle draw.
  • Battery days = available energy ÷ (daily use minus solar minus any generator charging you choose to count).
  • Generator hours = (fuel minus reserve) ÷ fuel use per hour at your expected load.

Days are rounded down to the nearest tenth. When solar covers your average use, the planner does not call that unlimited. It shows how long the battery lasts with no sun instead, because cloudy stretches and nights still drain it.

Plan your refills

Once you know your first limit, plan where to refill or dump. Search the water and dump station finder by city or ZIP, and use the propane refill finder on the same page. A listing does not guarantee a stop is open, has potable water or propane, or accepts RVs, so confirm with the operator before you drive. To budget the trip, use the boondocking cost calculator. For battery, solar, and inverter basics, read our RV power guide.

This planner gives estimates, not guarantees. Temperature, battery age, wiring, appliance cycling, weather, and gauge accuracy all change real results. Check equipment limits with the manufacturer.